Skip to content
English
Go to www.anacorp.com
  • There are no suggestions because the search field is empty.

How Do I Set Up My Generator?

A complete step-by-step setup guide and checklist to ensure your ANA generator is installed, configured, and performing at its best.

Overview

When it comes to temporary or backup power, getting your equipment up and running correctly is critical. Properly setting up your AIRMAN® generator is key to ensuring reliable performance and extending equipment life. This guide provides everything you need to confidently install and operate your ANA generator.

Step 1: Pre-Installation Preparation

Before installation begins, take time to plan. A few upfront checks can save hours of troubleshooting later.

  • Assess Your Power Needs
    • Determine whether your application requires single-phase or three-phase power.
    • Identify the correct voltage and amperage needed for your tools or equipment.
  • Select the Right Generator or System
    • Choose a unit from ANA’s full product line based on load size, application type, and runtime needs.
    • Consider add-ons like battery kits, SmartLoad™ activation, or auxiliary fuel connections.
  • Prepare the Installation Site
    • Make sure your location is flat, stable, and properly ventilated.
    • Verify any required local permits or compliance standards before setup.

Step 2: Installation and Connection

Now it's time to install and configure your equipment safely.

  • Position the Generator
    • Set your unit on a level surface with ample space for airflow and routine maintenance access.
    • Keep clearance around the generator as specified in the installation manual.
  • Connect Electrical Components
    • Secure all power cables, checking phase and voltage settings carefully.
    • Use the control panel to select the correct operating parameters.
  • Check Fuel and Fluid Levels
    • Fill the fuel tank and top off oil and coolant as required.
    • For longer runtimes, connect to an auxiliary fuel tank if applicable.

Step 3: Initial Startup and Safety Check

You're almost ready to power on—just a few final steps.

  • Perform a System Check

    • Inspect all wiring, fittings, and safety features.

    • Ensure the emergency shutdown system is active and accessible.

    • Start the unit using the manufacturer's recommended process.

    • Monitor performance and look for unusual noises, vibration, or output inconsistencies.Power On the Generator

Step 4: Optimize and Maintain Performance

Once your system is running, take steps to fine-tune efficiency.
  • Activate SmartLoad™ (If Equipped)
    • This system automatically adjusts load to prevent wet stacking and low-efficiency operation.
    • SmartLoad™ engages or disengages resistive load to protect your engine over time.
  • Run Equipment Test Loads
    • Connect your actual tools or systems to simulate a real use scenario.
    • Document baseline performance metrics for future maintenance tracking.
    • Follow your unit's manual to determine service intervals.
    • Use ANA’s support resources to maintain performance and track any issues early.Set a Maintenance Schedule

Step 5: Access Support and Resources

Need more help? ANA makes it easy to get the support you need.
  • Explore the ANA Knowledge Base
    • Access quick-start guides, user manuals, videos, and troubleshooting tools.
    • Bookmark articles for future reference as your equipment gets used.
    • Reach out for technical help or product-specific questions via anacorp.com or your regional sales representative.Contact ANA Support

Final Thought

By following this guide, you'll avoid common setup mistakes, maximize performance, and ensure your generator is ready for whatever the job demands.

 To make setup even easier, download the ANA Generator Setup Checklist and use it on-site or during installation reviews:

Generator Setup Checklist